QUESTION
I have recently purchased a Lotus Elan +2 that is completely dismantled and most of the parts are packed in boxes.
I have just started to install the heater and dashboard and have hit a problem.
Both the workshop manual and parts list show the heater orientation which I am beginning to doubt the accuracy.
I hope you can help me with on fitting up the heater control cables as they appear too long.
The cable from the dash ( Hot-------Warm-------Cold ) top slot going to the top lever on heater is 62cm long (the outter cable )
The cable from the dash ( Defrost------------------Interior ) lower slot, going to the bottom lever on heater is 80cm long (the outter cable )
The problems are too much spare cable and trying to fold this away behind the dash.
This then makes the operation of the controls very stiff .
I found that the control ,which screws to the dash was upside down.
I have reinstalled this the same as shown in the spare parts book.
With quadrants out the left hand side , lever with detente action on top , smooth action lever to bottom
If I have the controller right then I assume ,the top cable (Hot----Warm----Cold ) goes to the top fitting on the side of the heater (air temp lever)
The bottom cable ( Defrost--------Interior) goes to the bottom fitting on the side of the heater ( air distribution )
Inner cable is no problem as I will just cut this to suit the shortened outer cables.
L.H. - New Zealand
ANSWER
The control cables should exit the dashboard control unit left to right (towards the steering column)
The cables should then be routed over the top of the heater unit and be fed down vertically to the control flaps.
NOTE - When the dashboard control lever is set to cold position (off) it does not stop the hot water circulating through the heater matrix.
If you happen to live in a warmer climate, it is useful to install a heater tap on the water pump outlet so the hot water can be turned off.
Copyright © 2012 Lotus Marques
I have recently purchased a Lotus Elan +2 that is completely dismantled and most of the parts are packed in boxes.
I have just started to install the heater and dashboard and have hit a problem.
Both the workshop manual and parts list show the heater orientation which I am beginning to doubt the accuracy.
I hope you can help me with on fitting up the heater control cables as they appear too long.
The cable from the dash ( Hot-------Warm-------Cold ) top slot going to the top lever on heater is 62cm long (the outter cable )
The cable from the dash ( Defrost------------------Interior ) lower slot, going to the bottom lever on heater is 80cm long (the outter cable )
The problems are too much spare cable and trying to fold this away behind the dash.
This then makes the operation of the controls very stiff .
I found that the control ,which screws to the dash was upside down.
I have reinstalled this the same as shown in the spare parts book.
With quadrants out the left hand side , lever with detente action on top , smooth action lever to bottom
If I have the controller right then I assume ,the top cable (Hot----Warm----Cold ) goes to the top fitting on the side of the heater (air temp lever)
The bottom cable ( Defrost--------Interior) goes to the bottom fitting on the side of the heater ( air distribution )
Inner cable is no problem as I will just cut this to suit the shortened outer cables.
L.H. - New Zealand
ANSWER
The control cables should exit the dashboard control unit left to right (towards the steering column)
The cables should then be routed over the top of the heater unit and be fed down vertically to the control flaps.
NOTE - When the dashboard control lever is set to cold position (off) it does not stop the hot water circulating through the heater matrix.
If you happen to live in a warmer climate, it is useful to install a heater tap on the water pump outlet so the hot water can be turned off.
Copyright © 2012 Lotus Marques



